Return to Hyway High-Quality Nikasil Plated Cylinder Kit + Top End Rebuild Compatible with Husqvarna 350, 351, 353

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 2

0 of 0 people found the following review helpful:

February 11, 2024 Reviewer: Dave R. from Markville, MN United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Good as oem October 10, 2023 Reviewer: BRETT STANDKE from REDGRANITE, WI United States   Excellent machining on cylinder Was this review helpful to you?

0 of 0 people found the following review helpful:

April 18, 2023 Reviewer: Bernard Knadt from Macomb, MI United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

April 7, 2022 Reviewer: Peter Halvorsen from Richmond, VT United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Chainsaw rebuild kit January 17, 2022 Reviewer: Justin Coggins from Fort Bragg, CA United States   I recently received a upgraded rebuild kit for my husqvarna 350 chainsaw and it’s been amazing! It runs great and has lots of power, thank you so much! Was this review helpful to you?

0 of 0 people found the following review helpful:

Questionable Quality w/ update on 4/23/20 April 23, 2020 Reviewer: Robert H from Columbus, OH   I'm not sure about all of the 5 star ratings for this kit. I can confirm that the transfer port will  rub the flywheel, I chose to machine the flywheel down a little for the needed clearance. My main issue was with all of the tapped holes in the cylinder. The decompression button, spark plug, anti vibe mount, and 1 muffler bolt would not thread in without being cleaned up with a tap. Everything else fit and worked well, but buyer beware!  UPDATE! I had one of the wrist pin cir clips fail when an "ear" broke off and scored the piston and cylinder. I had fewer than 12 tanks of gas through it at the time and it was just starting to run really well, developing more power than it ever did with the stock jug on it. I contacted HL Supply, and after a little back and forth they sent me out a new kit as a replacement. Thanks to the team in customer service for taking care of my claim! Was this review helpful to you?

0 of 0 people found the following review helpful:

January 11, 2020 Reviewer: Joel Schwiebert from Topton, NC United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

December 19, 2019 Reviewer: Herb from Verona Island, ME United States   Fast shipping and great prices Was this review helpful to you?

0 of 0 people found the following review helpful:

Saw now runs fine. October 13, 2019 Reviewer: Glenn Warren from Kenosha, WI United States   Rebuilt a 2003 Husqvarna 346xp with scored cylinder. This kit included everything I needed. Look like good quality parts. Saw ribs well. Was this review helpful to you?

0 of 0 people found the following review helpful:

Quality September 23, 2019 Reviewer: Seth Kennedy from BEAUMONT, TX United States   Cylinder and piston was of good quality and did not see any visible defects when assembling. I did have to shave down the side of the cylinder to allow it to clear the flywheel though. Would have been a bigger issue without a Dremel. The e clips for the piston were impossible to get in and larger than OEM. Had to reuse the OEM e clips. The air filter did not fit my saw and so it is pretty useless. Was this review helpful to you?