Return to Non-Genuine Cylinder Kit for Stihl MS310 Replaces 1127-020-1218
Sort By::
Page of 2
Click to see more items


  0 of 0 people found the following review helpful:
 
5 of 5 November 22, 2022
Reviewer: chris biven from Bloomfield, KY United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Quality looks good upon receipt April 16, 2021
Reviewer: SK from Sandy, OR United States  
Pleased with overall appearance and quality. Time will tell. Bearings were Cross Performance brand.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 November 26, 2020
Reviewer: Shannon Bean from Westfield, MA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 July 26, 2020
Reviewer: Mike DeSilva from Williamston, MI United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 February 18, 2020
Reviewer: Rebecca Harris from Fries, VA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
1 of 5 new 47mm cylinder works in my saw October 10, 2019
Reviewer: Glen Patana from Holly Springs, NC United States  
The crankcase bolts broke off in a brand new cylinder(cheap bolts) so instead of sending me a new cylinder with a good set of bolts, I had to purchase a new cylinder and purchased bolts from Stihl because I didn't trust the the bolts from HL Supply.  Bottom line, the bolts should have never broke? So I wasted money on the first kit.........

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 February 14, 2019
Reviewer: Leonard Merrifield from Redding, CA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
3 of 5 OK but 3 small proplems March 1, 2018
Reviewer: Anonymous Person from OR United States  
Out of box there were 2 issues that had to be addressed and 1 that was due to the wrong information given in the "Description". First the grounding wire attach hole is tapped to a different pitch than OEM, easy fix but your out .25 cents on new hardware. Second the exhaust port was not flat/square so hi-temp sealant was needed to make sure exhaust would seal properly to muffler. Lastly, the "Description" states that it "Has hole for decompression valve", it does not and so I ordered 1 plug that was not needed. The fit & finish seems OK but will need to be ran for a season to judge & rate it fairly.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Lasted 5 minutes March 6, 2015
Reviewer: Joseph Fairfax from Fairfax, VA United States  
I had an expensive chainsaw with a scorched piston/cylinder. The Stihl dealership wanted as much as a new saw to repair it. This kit got my saw back up and working for a fraction of the cost.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 310 cylinder kit June 4, 2014
Reviewer: Eric Miles from Byron, IL United States  
For a lower cost kit this one had pretty clean ports and God quality

Was this review helpful to you?

   
  Click to see more items