Home > Chainsaw >

Meteor Cylinder Kit 49mm fits Stihl 039, MS390

Meteor Stihl 039, MS390 cylinder kit 49mm
 
Our Price: $141.95
FLASH Sale!: $129.95
Part #: MCC2377

Important:

Warranty for a New Cylinder Kit.pdf


Proposition 65 Warnings:

www.p65warnings.ca.gov



Stock Status: (Out of Stock)

Free Shipping
Qty:

Description Replaces the following OEM(s)
 
Meteor brand Nikasil plated cylinder assembly. Made in Italy.
Highest quality aftermarket kit. This is the closest to OEM you will find.
Fits: Stihl 039, MS390 chainsaw
Works as a big bore for 029, MS290, MS310
Replaces OEM Part: 1127 020 1216
Fits models:
  • Stihl 039, MS390

You may also like...
Piston ring compressor tools kit Non-Genuine Piston Pin Bearing for Stihl MS291, MS390
FLASH Sale!: $10.36
Part #: S97419

Add Free Shipping
FLASH Sale!: $2.57
Part #: H101413

Add Free Shipping
Piston ring compressor tools kit Stihl piston pin bearing replaces 9512 003 2340

Average Customer Review: Average Customer Review: 2.5 of 5 2.5 of 5 Total Reviews: 2 Write a review.

  0 of 0 people found the following review helpful:
 
1 of 5 just got a roughcasting December 15, 2020
Reviewer: allan Swearingen from El Paso, TX United States  
The cylinder was finished but most of the hols that would take a bolt was not taped and the mounting bolts on the exhaust  would not fit so I had to work over the bolts to get them to fit the casting. Payed for a quality  part and got something that was half done.

Was this review helpful to you?

  0 of 1 people found the following review helpful:
 
4 of 5 Casting imperfection exhaust stud groves. March 16, 2020
Reviewer: Charles Fisher from Johnstown, PA United States  
This is an excellent kit for the money, the only complaint I have is the casting where the exhausr studs slide into the jug were very rough. They would not let the stud slide in and out freely and when putting the gasket on because of the poor casting, it made the studs want to come inward toward each other, and you could not mount the muffler. After some light cleaning up worked fine, had to file the slots a little wider to make studs work correctly.

Was this review helpful to you?