Home > Husqvarna >

Cross Performance cylinder kit for Husqvarna 372 XP X-Torq
Husqvarna 372XP X-Torq cylinder kit
 
Our Price: $139.95
FLASH Sale!: $99.96
Part #: CP30372

Important:
Warranty for a New Cylinder Kit.pdf

Proposition 65 Warnings:
www.p65warnings.ca.gov


Stock Status:In Stock

Free Shipping
Qty:

Description Technical Specs Replaces the following OEM(s)
 
Premium quality Nikasil plated cylinder kit by Cross Performance. 50mm bore.
Includes high quality CABER (Italy) brand piston rings.
Fits: Husqvarna 365 X-Torq, 372XP X-Torq.
Replaces OEM part: 575 25 57-02

*This will ONLY fit X-TORQ saw models.
Fits models:
  • Husqvarna 365 X-Torq, 372XP X-Torq

    *This will ONLY fit X-TORQ saw models.

You may also like...
Piston ring compressor tools kit Star Tron 8 oz. Enzyme Fuel Treatment
FLASH Sale!: $10.36
Part #: S97419

Add Free Shipping
FLASH Sale!: $13.59
Part #: H51004

Add Free Shipping
Piston ring compressor tools kit Star Tron 8 oz. Enzyme Fuel Treatment

Average Customer Review: Average Customer Review: 4 of 5 4 of 5 Total Reviews: 3 Write a review.

  0 of 0 people found the following review helpful:
 
5 of 5 Great deal! April 28, 2021
Reviewer: Giovanna from Toronto, Ontario Canada  
Fit like original, and Italian made piston rings-would purchase again.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
3 of 5 manufacture defect September 23, 2019
Reviewer: Anonymous Person from BC, Canada  
Piston cylinder had lots of compression and good quality, but found out after 8 months something was wrong. Took cylinder off and the lining peeled off. Trying another one. Staff was not to keen about replacing a manufacture defect!!!

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
4 of 5 372xt cylinder kit September 6, 2018
Reviewer: Richard Norman from Rapid City, SD United States  
This is a pretty nice kit. Upon inspection I did find a divot below the exhaust port that you could feel and would scratch the piston when put in cylinder with out rings. I cleaned the area up with fine sandpaper.
  Ports and casting were very clean. Not a lot of excess slag anywhere.
  Squish band was measured and was very good right out of the box.
   Assembled saw runs and performs very well and has very good compression.
   I would recommend this kit as my small issue I feel is an isolated incident and it’s location was non critical. This kit also come with Caber Rings.

Was this review helpful to you?